Atrioventricular Valves. The AV valves (i.e., the tricuspid and mitral valves) prevent backflow of blood from the ventricles to the atria during systole, and the semilunar valves (i.e., the aortic and pulmonary artery valves) prevent backflow from the aorta and pulmonary arteries into the ventricles during diastole. These valves, shown in Figure 1 for the left ventricle, close and open passively. That is, they close when a backward pressure gradient pushes blood backward, and they open when a forward pressure gradient forces blood in the forward direction. For anatomical reasons, the thin, filmy A-V valves require almost no backflow to cause closure, whereas the much heavier semilunar valves require rather rapid backflow for a few milliseconds.

Fig1. Mitral and aortic valves (the left ventricular valves).

Function of the Papillary Muscles. Figure 1 also shows papillary muscles that attach to the vanes of the A-V valves by the chordae tendineae. The papillary muscles contract when the ventricular walls contract, but contrary to what might be expected, they do not help the valves to close. Instead, they pull the vanes of the valves inward toward the ventricles to prevent their bulging too far backward toward the atria during ventricular contraction. If a chorda tendinea becomes ruptured or if one of the papillary muscles becomes paralyzed, the valve bulges far backward during ventricular contraction, sometimes so far that it leaks severely and results in severe or even lethal cardiac incapacity.

Aortic and Pulmonary Artery Valves. The aortic and pulmonary artery semilunar valves function quite differently from the A-V valves. First, the high pressures in the arteries at the end of systole cause the semilunar valves to snap closed, in contrast to the much softer closure of the A-V valves. Second, because of smaller openings, the velocity of blood ejection through the aortic and pulmonary valves is far greater than that through the much larger A-V valves. Also, because of the rapid closure and rapid ejection, the edges of the aortic and pulmonary valves are subjected to much greater mechanical abrasion than are the A-V valves. Finally, the A-V valves are supported by the chordae tendineae, which is not true for the semilunar valves. It is obvious from the anatomy of the aortic and pulmonary valves (as shown for the aortic valve at the bottom of Figure 9-8) that they must be constructed with an especially strong yet very pliable fibrous tissue to withstand the extra physical stresses.

مواضيع ذات صلة

Phenotypic and Functional Properties of Erythroid Progenitor Cells

GRAPHICAL ANALYSIS OF VENTRICULAR PUMPING

Excitation-Contraction Coupling— function of calcium ions and the transverse tubules

PHYSIOLOGIC ANATOMY OF CARDIAC MUSCLE

الطحال Spleen

الثايمس Thumus

اللوزتان Tonsils

العقد الليمفاوية

الدورة الليمفاوية

تكوين الليمف

الليمف

الجهاز الليفاوي (مقدمة)